Tycon-power RPST2424-100-280 Manuel d'utilisateur télécharger pdf (Page 6)

Note: The green connector

on the controller may be-

come unplugged due to vi-

bration and the weight of the

cables. Be sure to add a zip

tie or other method to hold

the cables and relieve the

cable weight from the con-

nector.

An alternate high capacity (20A) controller is

shipped with the RPST12 systems with

280W solar panels and is also available on

the RPST24 systems. The controller has

wire terminal solar, battery and unregulated

load outputs.

STEP 12: Route the solar panel cables out thru the feedthrus and

install to the solar panel. Be sure to connect in the proper polarity, red

wire to + and black wire to –. Make sure connections are waterproofed.

STEP 13: Tighten all wire feedthrus. If they don’t tighten on a small

diameter wire, you can wrap some electrical tape around the wire in the

seal area to increase its diameter and make a better seal. The enclo-

sure needs some small amount of venting so be sure not to seal all

holes and feedthrus with silicon.

STEP 14: Make sure lid gasket is clean and free from any parti-

cles, then carefully close the cover, making sure that wires are clear of

the seam and hinge area. Use the special key to close the two cover

locks.

Controller Wire Terminal Output Wiring

Device 1

Device 2

FG = Frame Ground (Do Not Connect

to V-)

GND = V- (There are two V– connec-

tions:1 and 2)

+12V or +24V = V+ (There are two V+

connections: 1 and 2)

1 2 3 4 5 6 7 8 9 10 11 12

Pas de commentaire

Tycon-power RPST2424-100-280 Manuel d'utilisateur Page 6