Tycon-power RPST2424-100-280 Manuel d'utilisateur télécharger pdf (Page 2)

Qwik Install

STEP 1: Add Grounding Wire Between Door and Enclosure: Remove

plastic covers on copper studs

on inside of door and inside of

enclosure. Add jumper wire be-

tween 2 copper studs and use

copper washers and nuts to se-

cure.

STEP 2: Add wire feedthrus and

any necessary connectors into

the bottom connector plate. Attach the

connector plate to the bottom of the

enclosure using self tapping screws

provided.

STEP 3: Install hole plug in drain

hole in bottom right corner of the en-

closure.

STEP 4: Mount the DIN rail to the

door using screws provid-

ed. Mount any extra

equipment to the orange

backplate and secure the

backplate in the enclo-

sure. Note: The DIN rail

can also be mounted to

the orange backplate or

sides of enclosure if de-

sired.

1 2 3 4 5 6 7 ... 11 12

Pas de commentaire

Tycon-power RPST2424-100-280 Manuel d'utilisateur Page 2