Tycon-power RPDC12-9-10 Manuel d'utilisateur télécharger pdf (Page 2)

Qwik Install

STEP 0: Mount the solar panel to the bracket and to the pole. It’s best

to mount so that the solar panel shades the enclosure.

STEP 1: Connect the Battery to Controller BAT terminals. Be sure to

observe polarity. Black wire connects to battery negative terminal and

BAT(-) terminal on the controller. When a fully charged battery is con-

nected, the Green LOAD LED should light on controller.

STEP 2: Install battery to enclosure with battery terminals on right. In-

stall metal plate using 8 screws.

STEP 3: Install Cable Feedthru into center hole in bottom of enclosure.

Feedthru gasket is on outside of enclosure and nut inside. Tighten nut.

OPTION: add a drop of threadlocker to the nut to prevent acci-

dental loosening.

STEP 4: Install two bracket pieces to the back of enclosure using 4

screws. Bracket can be used for wall mounting or pole mounting.

STEP 5: Wire solar panel to the controller solar inputs. Observe

proper polarity. The solar panel should be facing South if in Northern

Hemisphere. Face North if in southern hemisphere.

STEP 6: Mount any electronics boards to the metal plate. Connect

your load to the controller LOAD output.

On the bottom of the enclosure there are two double D cutouts for

standard N Female bulkhead connectors which can be used for an ex-

ternal antenna or RF device. Just remove the hole plug to use this cut-

out.

1 2 3 4

Pas de commentaire

Tycon-power RPDC12-9-10 Manuel d'utilisateur Page 2